What you need
The bore is the width of each cylinder. The stroke is how far the piston travels, from the top of its run to the bottom. Look for them in the workshop manual for the engine, in millimetres or inches. If you're working with an engine on the bench, measure the bore across the cylinder and the stroke as the difference between the piston's highest and lowest points.
Their car, repainted from one photograph in whichever of the nine styles suits the room. Free preview first, accepted on screen before anything is charged.
From £19.99 · Poster

How it is worked out
Each cylinder sweeps out a short round column of air as the piston moves. Its volume is π ÷ 4 × bore² × stroke. Multiply by the number of cylinders and you have the capacity, also called displacement. With millimetres in, the answer comes out in cubic millimetres, and 1,000 of those make one cc.
| Bore | Stroke | Cylinders | Each cylinder | Capacity |
|---|---|---|---|---|
| 86 mm | 86 mm | 4 | 499.6 cc | 1,998 cc (2.0 litres) |
| 63 mm | 76 mm | 4 | 236.9 cc | 948 cc (0.95 litres) |
So an 86 mm bore with an 86 mm stroke gives π ÷ 4 × 86 × 86 × 86 = 499,557 mm³ a cylinder. Four of them make 1,998 cc, which is 2.0 litres to one decimal place.
Inches and cubic inches
For an older engine with its sizes in inches, choose inches and the calculator turns them into millimetres first, at 25.4 mm to the inch. That's the legal inch in the Weights and Measures Act 1985, read on 30 October 2026. A cubic inch is 25.4³ mm³, about 16.387 cc, which is how the cubic inch figure is worked out.
Rebores and what capacity doesn't tell you
A rebore makes the bore a little wider, so the capacity goes up a little. Type the new bore to see by how much. Capacity is only how much air the cylinders sweep. It doesn't tell you the power: for that, see what engine displacement means, or turn a power figure into other units with the bhp to kW converter.
Written by Craig Fearn, Petrol & Ink. Last updated .